Page 1
FAX: 847-367-8981 TOLL FREE: 800-323-9793 NOTE: This document contains operation and EMAIL: SERVICE@CARTER-HOFFMANN.COM cleaning instructions only. For the complete Owner’s Manual, go to www.carter-hoffmann.com or call 800.323.9793 FEATURES & OPERATING CONTROLS Heat Indicator Lights for Top and Bottom Heaters Increase...
Page 2
NORMAL OPERATION NOTE: See PROGRAMMING INSTRUCTIONS on next page with instructions on how to 1. Press the POWER SWITCH to ON. Illuminated portion of switch enable DAYPARTS will glow, indicating power is ON. Pre-heat cabinet for 20 min- utes. When first turned on, digital readout will display “LO” until the cabinet reaches 122°F.
Page 3
CONTROLLER PROGRAMMING SETTING INDIVIDUAL HEATER TEMPERATURE SETPOINTS (in programming mode using P1 thru P6 TEMP setpoint range: NOTE: If P1 is not displayed, press ARROW KEY 122°F to 225°F. 1. With appropriate P# selected, press and hold the TEMP KEY for approximately 2 seconds, the display will flash the current set- ting for the lower heater;...
Page 4
CLEANING INSTRUCTIONS CAUTION: CAUTION: Unplug cabinet and allow to cool before cleaning. ELECTRIC SHOCK HAZARD Cleaning: Disconnect appliance from electric power before cleaning. 1) Remove power cord plug from outlet. Allow cabinet to cool. 2) Remove pans and pan covers. Wash with mild detergent and rinse thoroughly with clean water and allow to dry.
Need help?
Do you have a question about the MZ Series and is the answer not in the manual?
Questions and answers