Page 2
SAFETY PRECAUTIONS WARNING: ELECTRIC SHOCK HAZARD WARNING All service requiring access to non-insulated components must be performed by qualified service personnel. Failure to heed this warning may result in severe electric shock. CAUTION: ELECTRIC SHOCK HAZARD Disconnect this appliance from electrical power before performing any maintenance or service.
Page 3
FEATURES & SPECIFICATIONS • Top-mounted enclosed water reservoir Precision-engineered heat ducts with blower cannot be contaminated by food debris. for even heat and humidity. • 90% humidity attainable at high temperatures. Temperature range of 85°F - 200°F. • Simple dial controls for heat and humidity. Easy color match to set proper temperature and humidity.
Page 4
(15) days from the date the delivery was made to you. Be sure to retain the container for inspection. Carter-Hoffmann cannot assume liability for damage or loss incurred in transit, freight damage is not covered under warranty. We will, however, at your request, supply you with the necessary documents to support your claim.
Page 5
INSTALLATION and STARTUP LOCATION WARNING: For proper operation and maximum performance, locate the unit Risk of personal injury in an ambient air temperature of 70ºF (21ºC). Installation procedures must be Avoid placement in areas near exhaust fans or where there are performed by a qualified technician active air movements.
Page 7
NORMAL OPERATION CAUTION: The Logix6 Series Humidified Holding Cabinet is equipped with two dials to control the temperature and humidity settings. Before using, HOT SURFACE familiarize yourself with the cabinet controls. See detail on page six of this manual. Inner surfaces of the unit...
Page 8
NORMAL OPERATION (CONT.) CAUTION: RELATIVE HUMIDITY LEVELS FOR DIAL SETTINGS HOT SURFACE The chart below indicates the settings for temperature and humidity. The key is to match the Low (L), Medium (M) and High (H) relative humidity levels in each color band on the humidity dial with the cor- Inner surfaces of the unit responding color band at your desired temperature setting.
Page 9
FOOD HOLDING GUIDE PRODUCT SET TEMPERA- RELATIVE HUMIDITY MAXIMUM (Uncovered Food, except where TURE TIME noted) (°F /°C) (MINUTES) CAUTION: SAFE Bacon, Canadian 180°F / 82°C FOOD HOLDING Bacon, Crisp 180°F / 82°C NONE REQUIRED PRACTICES Baked Potato 180°F / 82°C RECOMMENDED Cooking food to a safe tem- Biscuits...
Page 10
DAILY CLEANING PROCEDURES CAUTION: 1. After all food products have been removed from the cabinet, turn the power switch to “OFF” and allow the cabinet to cool ELECTRIC SHOCK completely. HAZARD Disconnect appliance from 2. Unplug the unit prior to any cleaning. electric power before cleaning.
Page 11
CABINET MAINTENANCE CASTERS WARNING: DO NOT perform Caster bearings are equipped with Zerk grease fittings so that they these procedures may be easily lubricated with a grease gun. Lubricate bearings at while the cabinet is turned on least once every six months. or heated.
Page 13
REPLACEMENT PARTS Part Number Description Use only 18600-0046 Hi limit—open at 300°F, close at 250°F (OEM) original 18602-0083 On/Off switch 20 Amp equipment 18602-0031 Switch boot manufacturer 18605-5025 Power cord replacement parts. Us- 18606-0221 5-20P plug ing unauthorized parts 18617-0011 Cord grip may cause serious in- Verify w/ factory...
Page 14
NOTE: NOTE: The technical content of this manual, For warranty service, call Carter-Hoffmann including any wiring diagrams, schemat- direct at 800-323-9793 for authorization, ics, parts breakdown illustrations and / or we will dispatch the nearest authorized adjustment procedures, is intended for service agency.
Page 15
Repair or replacements under this warranty will be performed, unless otherwise authorized in writing by CARTER-HOFFMANN, at its factory. All parts or components to be repaired or replaced under this warranty are to be shipped prepaid to CARTER-HOFFMANN, with reimbursement credit for such part or component to be given if found by CARTER-HOFFMANN to be defective.
Need help?
Do you have a question about the Logix6 Series and is the answer not in the manual?
Questions and answers