Extang TRIFECTA 2.0 Installation Sheet page 4

10
Open the tailgate, swing the tail clamps down from the stowed position and slide them toward the truck bed rail.
Swing the clamps and pull down so the clamp jaw is tucked under the rear truck bed rail bracket. NOTE: the clamp
jaw fits up into the bracket notch.
11
The tethers come installed looped
over the bed cover bow with a
clamp at the other end. Hook the tether
onto the truck bed tie-down. Install the
tethers on both sides of the cover.
DRIVING WITH THE
TONNEAU OPEN
Release the rear clamps
and fold the cover forward.
Extang Corporation • 5400 S. State Road, Ann Arbor, MI 48108 • 800-877-2588 © Extang Corporation, 2022
IMPORTANT: Before folding the second section
of the cover, the rear clamps must be stowed
into the rail to prevent damage to the fabric.
Failure to stow the handles will
puncture the
tarp and
void the
warranty.
Fold the cover forward and fasten
BOTH straps to the front rail. Check
that the straps are tight.
Part# 31920166-30 Rev. 6-27-22