Gps Data Export And Firmware Update - Megger digiPHONE+2 User Manual

8

GPS data export and firmware update

Multi-functional PC software is available with the Ferrolux/Digiphone management
Introduction
software that can be used for the following application purposes:
The latest version of the software can be downloaded from the product page on the
Megger website.
In order to install and use the software, your system must fulfil the following requirements:
Proceed as follows to establish a connection between the indicator unit / the sensor and
Making a connection
the software:
• Exporting of the tracing measurement series
• Firmware upgrade for the indicator unit
Firmware upgrade at various sensors (iFS, DPP-SU)
•
Operating system: 64 Bit, Windows 7 or later
•
• Processor: Intel i5 or higher
• RAM: min. 4 GB
Interfaces: USB 2.0
•
Step Action
1 Connect the indicator unit or the sensor via the connection cable available as
a special accessory (see page 12) to the USB interface of the PC.
2 Switch on the indicator unit (not necessary with a sensor).
3
Start the software.
Result: The software should detect the connected device shortly after
starting, and display it on the main screen as confirmation.
GPS data export and firmware update
90