Using The Audiofuse X8 Out; Device Connections - Arturia AUDIOFUSE X8 OUT User Manual

4. USING THE AUDIOFUSE X8 OUT

Hooking up your AudioFuse X8 OUT and configuring its inputs is a simple process.

4.1. Device connections

1. Connect your analog devices to the rear-panel outputs.
2. Connect your ADAT optical cables to the ADAT outputs on your audio interface.
3. If you're using external Word Clock, attach the BNC cable from your master
clock source. Set the HiZ switch accordingly, as explained in the chapter on
synchronization
4. Make sure your interface recognizes the presence of the ADAT outputs and their
chosen clock/sync settings. Consult your device's user manual if things don't
seem to be connecting properly, and don't forget to verify the type of
you're using.
5. Use your interface to determine which signals from your DAW are routed to
which outputs. This is where you'll set up alternate sets of check monitors, a
surround mix, a subwoofer output, or whatever other application you might have
in mind.
You're now ready to go! That wasn't so hard, was it?
8
Hooking up the AudioFuse X8 OUT to your system
[p.9].
Arturia - User Manual AudioFuse X8 OUT - Using the AudioFuse X8 OUT
sync [p.9]