UniPOS 7000-1MC Product Safety Manual

Product Safety Guide
Fire alarm control panel
ENGLISH
Please read this guide, before attempting to operate the product, or before attempting any maintenance.
Failiure to follow these instructions may result in an increased risk of personal injury or damage to property,
including through re, electrical shock, burns or su ocation. UniPOS shall not be liable for damage caused
where the product owner has failed to follow the instructions set out in this guide.
Read all the instructions. Save them for later reference.
Fuse symbol
Before replacing any fuse the mains power (AC) shall be disconnected from the mains board in order to de-energize the phase
conductors. The 7000-1MC control panel is permanently connected equipment and must be connected to an all-pole mains switch,
FUSE
incorporated in the electrical installation of the building.
Equipment class I - PE symbol
Connection of the equipment protective earthing
conductor to the installation protective earthing
conductor in the mains board is needed.
Hazardous waste
When the marking below is shown on the product and/or its
literature, it means that the product should not be disposed with
other household wastes at the end of its life cycle. During waste
treatment, disposal and collection, please separate the product
from other types of wastes and recycle it responsibly to promote
the sustainable reuse of material resources. This product should not
be mixed with other commercial wastes for disposal.
PB Free
P P b b
Meets the Pb-free requirements/de nitions adopted by the RoHS
Directive 2002/95/EC – lead level in any of the raw materials and
Pb the end product is less than or equal to 0.1% by the weight.
Basic hazards
Before removing any of the safeguards below please switch o the all-pole main switch in
the mains board of the building.
The Fire alarm control panel 7000-1MC equipment must be permanently connected to a
ES3 / PS3
dedicated single pole, 16 A, curve C circuit breaker, installed in the building's main board.
7000-1MC
the instructions carefully!
Before use, read
Symbols and conventions
DANGER
90-264VAC/50-60Hz
CAUTION
HEAVY
LOAD
re alarm sysrems
www.unipos-bg.com
DANGER symbol
Dangerous voltage under the Power Supply
Unit chassis 90-264VAC/50-60Hz
Electrostatic-sensitive components
This product contains static-sensitive devices.
Avoid any electrostatic discharge when
control panel is opened
Caution Heavy load
Transportation package tend to be
carried by two persons
To open panel:
remove the screws
1
V1/08.2023