Download Print this page

Ledj HEX Par 9 MKII Exterior Fixture User Manual

Advertisement

Quick Links

HEX Par 9
MKII
Exterior Fixture
User Manual
Order code: LEDJ226

Advertisement

loading
Need help?

Need help?

Do you have a question about the HEX Par 9 MKII Exterior Fixture and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ledj HEX Par 9 MKII Exterior Fixture

  • Page 1 HEX Par 9 MKII Exterior Fixture User Manual Order code: LEDJ226...
  • Page 2: Safety Advice

    Safety advice WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CARE- FULLY BEFORE YOUR INITIAL START-UP! • Before your initial start-up, please make sure that there is no damage caused during transportation. • Should there be any damage, consult your dealer and do not use the equipment. •...
  • Page 3 Product overview & technical specifications HEX Par 9 MKII Exterior Fixture IP65 The exterior HEX Par 9 features 9 x 12W six-colour LEDs, giving smooth colour mixing from rich saturated hues to subtle pastel shades, controlled via a 4 push button LED menu which allows for easy access to the modes including DMX, auto and master/slave.
  • Page 4 Operating instructions IMPORTANT! PLEASE NOTE: The LED display for this fixture has a menu locking function where after 30 seconds of inactivity it will lock. To unlock the menu you must hold the menu and enter buttons down for 2 seconds. DMX mode: d001 To select the DMX address, press the “MENU”...
  • Page 5 Operating instructions Colour change mode: CC-- To access colour change mode press “MENU” until the display shows on the LED display. Press “ENTER” to confirm the setting. Use the “UP” and “DOWN” buttons to adjust the speed between CC00 CC99 .
  • Page 6: Dmx Setup

    This fixture can be controlled via DMX-512 protocol. The DMX address is set on the back of the unit. Further DMX cables can be purchased from all good sound and lighting suppliers or Prolight Concepts dealers. Please quote: LEDJ 1m Interior - LEDJ 1m Exterior LEDJ 2m Exterior...
  • Page 7: Line Termination

    DMX setup Notice: Be sure to follow the diagrams below when making your own cables. Do not connect the cables shield conductor to the ground lug or allow the shield conductor to come in contact with the XLRs outer casing. Grounding the shield could cause a short circuit and erratic behaviour. Special note: Line termination: When longer runs of cable are used,...
  • Page 8: Weee Notice

    WEEE notice Correct Disposal of this Product (Waste Electrical & Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed of with other household wastes at the end of its working life.

This manual is also suitable for:

Ledj226