Kenmore 75085 - 8,000 BTU Single Room Thru-The-Wall Air Conditioner Owner's Manual page 11

JV: [o ujiKo] i
PROCEDURE C
W
To achieve rearward slope for unit draining,
remove the backing from the 1113/ld' shim
strips and attach them as shown below in Fig.
23. The higher portion of shim is to be placed
in front of the rib on the base of wall sleeve.
FIG. 22
16,,i 16,,i
FIG. 23
• Air conditioners coveredin this manualposean
excessiveweighthazard.Twoor morepeopleare
neededto moveand installthe unit.
To preventinjuryor strain,useproperliftingand
carryingtechniques when movingunit.
• Whenhandling the air conditioner,be carefulto avoid
cutsfrom sharpmetalfins on front and rearcoils.
• Makesureair conditioner doesnotfall during
removal.
• If unitdoesnotoperateafter installation check,to be
surethe circuitinterrupter has notbeentripped.Refer
to the Troubleshooting g uidefor resetprocedure.
_J Remove the metal rear grille and replace it with
the plastic rear grille.
Remove the -Plastic rear grille
metal rear gl
FIG. 24
_'_ Install the new unit into the wall sleeve
_ ssemble trim as described in Step 6,
Procedure A.
-11 -