3D Systems Figure 4 Standalone User Manual page 126

8/12/22, 10:32 AM
The printer has three safety sensors that, when tripped, will abort the
current print job without warning. In any of these cases, you will see the
screen at the right and the elevator will move to the o oad position.
1. Lid - Because the resin cures with UV light, exposure of the printed part during
printing to any other light besides that of the projector can cause a failed build
and can cure the resin in the resin tray. For this reason, if you open the printer
lid or lower-chamber door during printing, the print job will be aborted.
2. Front Door - To avoid operator exposure to optical radiation, the printer will also
abort the current job if the front door of the printer is opened during printing.
3. Catch Tray - In the unlikely event that the catch-tray sensor malfunctions during
a build, or if the catch tray becomes loose during a build, the print job will abort
to protect the bottom of the print engine.
CAUTION: Take care not to place the printer in a place where it
might be run into or shaken, causing any of the above actions
to happen accidentally.
One of the three sensors might also trip just after you press the Start
Job button in Step 5 of the section
pending job and you will see the screen below:
Tap "Abort" Button
infocenter.3dsystems.com/figure4standalone/print/book/export/html/526
User Guide
Start Printing. This will abort the
126/236