Page 1
DISCONNECT ALL SUPPLY CORDS BEFORE MOVING OR CLEANING/SERVICING Failure to adhere to the operation, cleaning and maintenance instructions detailed in this manual could affect the warranty of your oven. FILE 134 FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 2
CONTINUOUS BEAD AROUND THE PERIMETER OF THE UNIT. “NSF REQUIRES THAT THIS EQUIPMENT IS TO BE INSTALLED WITH ADEQUATE BACKFLOW PROTECTION TO COMPLY WITH APPLICABLE FEDERAL, STATE AND LOCAL CODES.” FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 3
The switch disconnector must meet the specification requirements of IEC 60947. The supply to this machine must be protected by a 30mA RCD FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 4
Indicates a hazardous situation which, if not avoided, WARNING will result in electric shock. Indicates a hazardous situation which, if not avoided, CAUTION will result in minor or moderate injury. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Designed to be stackable, without the requirement for a separate support. The high-speed fan and ring element provides efficient air circulation and an even bake across a range of products FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 7
2" (50mm) clearance is required at the back and sides of the oven and 10” (254mm) above to allow adequate circulation of air for cooling. 46” 34” 4” FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
The instructions must be readily accessible for the operator. CAUTION THIS APPLIANCE HAS MULTIPLE SUPPLY CORDS. DISCONNECT ALL SUPPLY CORDS BEFORE MOVING OR CLEANING/SERVICING FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
NSF approved sealant around the perimeter and attached by two brackets M189-05-00900 (one each side) at the rear. OVEN BASE CLAMPING BRACKET CLAMPING BRACKET M189-05-00900 M189-05-00900 LEFT SIDE RIGHT SIDE FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 11
00900 (one each side) at the rear. 7. Fix top sealing ring M189-01-02000 over top pipe with NSF approved silicone sealant. SILICON SEALANT (NSF APPROVED) SILICON SEALANT (NSF APPROVED) FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
6.0 ISOLATION To stop the oven in an emergency, Unplug the oven from the outlets. (THERE ARE TWO CABLES) FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
CLEANING SOLUTION, OR OTHER LIQUIDS TO ENTER THE ELECTRICAL PANELS OR CONNECTIONS. 3) DO NOT REMOVE THE REAR PANEL INSIDE THE OVEN.THIS ALLOWS ACCESS TO THE FAN ASSEMBLY AND COULD CAUSE INJURY. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Ensure that the panel is pushed fully back and turn the latch plates to secure in place. SLOT AT REAR PIN AT REAR OF SIDE PANEL OF OVEN SLIDE SIDE PANEL OVER LOCATING PINS. TOP AND BOTTOM FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 15
STEAM, CLEANING SOLUTION, OR OTHER LIQUIDS TO ENTER THE ELECTRICAL PANELS OR CONNECTIONS. DO NOT REMOVE THE REAR PANEL INSIDE THE OVEN.THIS ALLOWS ACCESS TO THE FAN ASSEMBLY AND COULD CAUSE INJURY. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 16
2 minutes. Use this feature for an additional minute of bake time at the end of a cycle from one key press. Oven will maintain the set temperature of the last selected program. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 17
Hold the P key (5), together with the STOP key (4) for 5 seconds. Press start - “Prb” is displayed FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19 Press (8) to show “– 0” for disabled or again to show “-1” for enabled...
GLASS AND FRAME Pt No.B721-67-008 Pt No.B721-67-010 Pt No.B721-67-009 Refit glass front, taking care that gasket is in position around stainless steel frame. • Re-connect oven and test. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 19
DOOR HANDING HOW TO CHANGE THE OPENING DIRECTION OF THE DOOR The following instructions are a guide for technicians. It is not recommended that the customer tries this. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Page 39
Fax. +44(0)1792 561016 Spares Tel. +44(0)1792 564039 Email:mono@monoequip.com www.monoequip.com As it is our policy to improve our machines continuously, we reserve the right to change specifications without prior notice. FG 189 4 TRAY 26 x18 (UL style) Classic Dualcord Mono RevA19 06-11-19...
Need help?
Do you have a question about the CLASSIC BX and is the answer not in the manual?
Questions and answers