Table Of Contents - CENTURION SYSTEMS INTERCOM HANDSET Installation Manual

Contents
1. INTRODUCTION
1.1. Important Safety Information
2. SPECIFICATIONS
2.1. Physical Dimensions
2.2. Technical Specifications
3. PRODUCT IDENTIFICATION
4. REQUIRED TOOLS AND EQUIPMENT
5. INSTALLATION
5.1. Entry Panel Installation
5.1.1. Wall-mounted Installation
5.1.2. Gooseneck Installation
5.2. Intercom HANDSET Installation
6. WIRING
6.1. Requirements for 12V DC Operators
6.2. Requirements for 24V DC Operators
6.3. Door Lock Drive
6.4. Wiring the Gate Status LED
6.5. Full Site Wiring Diagram (12V DC Operators)
6.6. Full Site Wiring Diagram (12V DC Operators)
6.7. INTERCOM Switch Wiring
7. COMPLETING THE INSTALLATION
7.1. Group and Volume Settings
7.1.1. Entry Panel and Selector Switch
7.1.2. One- or Two-Button Entry Panel Configuration
7.1.3. HANDSET call Group Selector Switch and Volume Control
7.2. Checking Functions
8. FAULT-FINDING GUDE
9. WARRANTY INFORMATION
Icons used in this manual
This icon indicates tips and other information that could be useful during the
installation.
This icon denotes variations and other aspects that should be considered during
installation.
This icon indicates warning, caution or attention! Please take special note of
critical aspects that MUST be adhered to in order to prevent injury.
page 3
Page 4
Page 6
Page 8
Page 8
Page 9
Page 10
Page 11
Page 12
Page 12
Page 12
Page 12
Page 16
Page 20
Page 21
Page 21
Page 22
Page 22
Page 23
Page 24
Page 25
Page 26
Page 26
Page 26
Page 26
Page 26
Page 27
Page 27
Page 26
www.centsys.com