Printing Via Wi-Fi Connectivity - LulzBot mini3 Start Here Manual

Printing via Wi-Fi Connectivity

6.4
It is unnecessary to slice a .gcode file if you intend to print via Wi-Fi, as a pre-supplied .gcode is already
loaded into Mainsail. Cura LulzBot Edition, select Save to Disk in the lower right hand corner. Save your .gcode
onto your computer. Return to the web browser with your Mini 3's IP address that opened Mainsail.
!
Before starting a print, check that your printer is ready. The hot end is still hot, use caution:
• Confirm that all packaging has been removed from your Mini 3
• Verify that the 3D printer is in a well-ventilated area, on a flat and level surface, and has 30cm (12in)
clearance in all directions.