LulzBot TAZ 5 Quick Start Manual
Hide thumbs Also See for TAZ 5:

Advertisement

Quick Links

Start Here
unpacking your
TAZ 3D printer
Save all packing materials,
packing clips, inserts,
documents, and the box in case
you need to ship your printer or
contact customer support.
1
Remove the ccessory Tray foam insert from the
box, set aside.
2
Slide out the tool bag and foam padding from the
left side of the printer frame.
3
While keeping the printer in the box, pick up by
the black aluminum frame and rotate the printer
and foam 90 degrees - setting it upwright within
the box. Make sure name plate at top is UP. Remove top
foam.
Ready to keep going?: https:/ /www.LulzBot.com/next
4
A
Remove the printer bed assembly (Y-axis)
packed in the body of the printer by sliding it up
6", freeing it from the packing foam.
B
Rotate printing bed assembly, tilting the bottom
toward front of box. Lower entire bed into box so it is
parallel with printer frame, then lift out and set aside.
Carefully remove printer frame from box and set it on a
sturdy, flat surface - you're ready for assembly!
next up:
Setting up your printer
Share ideas & collaborate: Forum.LulzBot.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TAZ 5 and is the answer not in the manual?

Questions and answers

Summary of Contents for LulzBot TAZ 5

  • Page 1 Make sure name plate at top is UP. Remove top foam. Carefully remove printer frame from box and set it on a sturdy, flat surface - you're ready for assembly! next up: Setting up your printer Ready to keep going?: https:/ /www.LulzBot.com/next Share ideas & collaborate: Forum.LulzBot.com...
  • Page 2 Locate the four Y axis bolts on the T Z frame (see green circles below). Turning counter clockwise, remove each Y axis bolt and set aside. Remove red protective packing clips from Z and Y axis smooth rods. Ready to keep going?: https:/ /www.LulzBot.com/next...
  • Page 3 Wrap and tighten the zip tie around the Y axis wiring and the black Y axis frame extrusion. Share ideas & collaborate: Forum.LulzBot.com...
  • Page 4 Use the image to the right to reference how the rear of the electonics enclosure should appear with all four plugs connected. Check that the locking sleeve of each connector is firmly hand tightened. Buy printers, parts and plastics at LulzBot.com...
  • Page 5 1 50mm ruler to measure the distance from the bottom Objects . of the X axis smooth rod and the top surface of the Y axis aluminum bed plate on the left side. next up: Create your first 3D print Share ideas & collaborate: Forum.LulzBot.com...
  • Page 6 4. Home Printer temperature settings will work for HIPS as well. For PL use 205C for the hot end and 60C for the bed. These temperatures are for Lulzbot filaments. You may need to home Use the buttons to home the X axis and Y adjust the temperature depending on the filament axis, then the Z axis.
  • Page 7 For more information, call +1 -970-377-1 1 1 1 or email support@lulzbot.com 626 West 66th Street, Loveland, Colorado 80538 US very very High perfect high LulzBot is a trademark of leph Objects, Inc. 201 5 leph Objects, Inc. Buy printers, parts, and plastics at LulzBot.com...
  • Page 8 ALL AT LULZBOT.COm Your go-to outlet for the highest quality filament and parts. We test all materials extensively before adding them to our store - because efficient innovation shouldn't be slowed by less-than-perfect materials. Buy printers, parts, and plastics at LulzBot.com...

Table of Contents