Table of Contents
Advertisement
Mounting & Installation
Caution!
Installation and connection should only be carried out by a quali ed
ƒ
person.
Only quali ed electricians or authorised service sta are permitted to
ƒ
open the thermostat.
If the thermostat is used in a way not speci ed by the manufacturer, its
ƒ
safety may be impaired.
Prior to setting the thermostat, it is necessary to complete all required
ƒ
settings described in this section.
This thermostat can be mounted in the following ways:
1) Directly mounted on wall.
2) Free standing - Stand Included.
Note:
For accurate temperature control it is recommended to mount the
thermostat as per the installation drawing on Page 11.
*If installing multiple CP4
Note:
If installing multiple CP4
minimum of 25cm distance between receivers.
/ CP4
V2
V2
/ CP4
-HW please ensure to keep a
V2
V2
RFRP
Room Thermostat
V2
-HW please see page 15 & 50.
CP4
V2
9
Advertisement
Table of Contents
Need help?
Do you have a question about the CP4 V2 and is the answer not in the manual?
Questions and answers
In programming the controller how do you set the on and off times for the heating
To set the on and off times for heating in the EPH Controls CP4 V2 controller:
1. Press the PROG button.
2. If in 5/2 Day mode, programming for Monday to Friday is selected first.
3. Use the + and - buttons to adjust the P1 time, then press confirm.
4. Use the + and - buttons to adjust the P1 temperature, then press confirm.
5. Repeat this process for P2 to P6 times and temperatures.
6. After completing Monday to Friday, programming for Saturday and Sunday is selected.
7. Adjust P1 to P6 times and temperatures using the same process.
8. Press confirm to save the settings.
For 7 Day mode, each day can be programmed individually. In 24 Hour mode, all 7 days share the same times and temperatures.
This answer is automatically generated