Table of Contents
Advertisement
Mounting & Installation
1)
The mounting height should be 1.5 metres above the oor level.
2)
The thermostat should be situated in the room where the
heating is to be controlled.
The place of installation should be chosen so that the sensor can
measure the room temperature as accurately as possible.
Choose the mounting location to prevent direct exposure to
sunlight or other heating / cooling sources when mounted.
3)
Fix the mounting plate directly to the wall with the screws provided.
4)
Attach the thermostat to the mounting plate.
5)
Lower the ap at the front of the thermostat. There is a battery
compartment located below the buttons. Apply downward
pressure to remove the cover.
6)
Insert the 2 x AA batteries and the thermostat will turn on.
Close the battery compartment.
10
Continued
RFRP
Room Thermostat
V2
CP4
V2
Advertisement
Table of Contents
Need help?
Do you have a question about the CP4 V2 and is the answer not in the manual?
Questions and answers
In programming the controller how do you set the on and off times for the heating
To set the on and off times for heating in the EPH Controls CP4 V2 controller:
1. Press the PROG button.
2. If in 5/2 Day mode, programming for Monday to Friday is selected first.
3. Use the + and - buttons to adjust the P1 time, then press confirm.
4. Use the + and - buttons to adjust the P1 temperature, then press confirm.
5. Repeat this process for P2 to P6 times and temperatures.
6. After completing Monday to Friday, programming for Saturday and Sunday is selected.
7. Adjust P1 to P6 times and temperatures using the same process.
8. Press confirm to save the settings.
For 7 Day mode, each day can be programmed individually. In 24 Hour mode, all 7 days share the same times and temperatures.
This answer is automatically generated