Operation; Switching The Product On/Off; Enabling/Disabling The Automatic Power-Off Function; Turning The Backlight On Or Off - Parkside PWM B2 Operation And Safety Notes

Anemometer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 32
˜ Operation
˜ Switching the product on/off
Switching on: Press
 
[
4 ]
 
backlight for approx.1 second before entering measurement mode.
In measurement mode, the display shows the current wind speed and
temperature (Fig. C).
Switching off: Press
 
4 ]
[
 
˜ Enabling/disabling the automatic power-off
function
When the product is switched on, press and hold
 
2 seconds to enable or disable the automatic power-off function.
When the automatic power-off function is enabled,
 
the display 
. In this case, the product switches off automatically if no
3 ]
[
button has been pressed for approx. 20 minutes.
42
GB/IE
. The display 
shows all segments and
3 ]
[
again.
 
for approx.
4 ]
[
 
is shown on
8 ]
[
˜ Turning the backlight on or off
When the product is switched on, press and hold
 
2 seconds to turn the backlight on or off.
˜ Selecting the unit of measurement
Press UNIT 
to enter the setting mode. SET 
1.
[
5 ]
display 
.
3 ]
[
2.
The wind speed unit m/s 
15 ]
[
this unit is selected.
Repeatedly press UNIT 
3.
5 ]
[
4.
When the desired unit flashes on the display 
After 2 seconds, the selected unit is saved automatically. The product
returns to measurement mode.
 
for approx.
6 ]
[
is shown on the
13 ]
[
flashes on the display 
. This means, that
3 ]
[
to toggle between the available units.
, stop pressing UNIT 
3 ]
[
.
5 ]
[

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PWM B2 and is the answer not in the manual?

This manual is also suitable for:

434250-2304

Table of Contents