Before First Use; Operation; Switching On/Off - Parkside PWM A1 Operation And Safety Notes

Risk of leakage of batteries / rechargeable
batteries
Avoid extreme environmental conditions and
temperatures, which could affect batteries / rechargeable
batteries, e .g . radiators / direct sunlight .
If batteries / rechargeable batteries have leaked, avoid
contact with skin, eyes and mucous membranes with the
chemicals! Flush immediately the affected areas with fresh
water and seek medical attention!
WEAR PROTECTIVE GLOVES! Leaked or
damaged batteries / rechargeable batteries
can cause burns on contact with the skin . Wear
suitable protective gloves at all times if such an
event occurs .
In the event of a leakage of batteries / rechargeable
batteries, immediately remove them from the product to
prevent damage .
Only use the same type of batteries / rechargeable
batteries . Do not mix used and new batteries /
rechargeable batteries .
Remove batteries / rechargeable batteries if the product
will not be used for a longer period .
Risk of damage of the product
Only use the specified type of battery / rechargeable
battery!
Insert batteries / rechargeable batteries according to
polarity marks (+) and (–) on the battery / rechargeable
battery and the product .
Use a dry lint-free cloth or cotton swab to clean the
contacts on the battery / rechargeable battery and in the
battery compartment before inserting!
Remove exhausted batteries / rechargeable batteries
from the product immediately .
10 GB
˜ Before first use
Remove the protective film from the display
enclosed batteries .
Inserting/changing the batteries
Empty batteries can falsify the measured result .
When appears in the display
[ 9 ]
batteries are almost drained and must be replaced:
Switch off the product .
–
Open the battery compartment
–
Remove the used batteries .
–
Insert 3 batteries (LR03/AAA) into the battery
–
compartment . Observe the correct polarity .
17 ] [
Close the battery compartment
–
NOTE: Do not press any button while changing the
batteries .
˜ Operation
˜ Switching on/off
Switching on: Press
segments briefly before entering measurement mode . In
measurement mode, the display shows the current wind
speed and temperature (Fig . C) .
Switching off: Press
. Insert the
[ 3 ]
, the inserted
[ 3 ]
.
[ 17 ]
.
17 ] [
. The display shows all
[ 4 ] 3 ] [
again .
[ 4 ]