Use a dry lint-free cloth or cotton swab to clean the contacts on the
battery / rechargeable battery and in the battery compartment before
inserting!
Remove exhausted batteries / rechargeable batteries from the product
immediately.
First use
Unpacking the product and basic cleaning
1.
Take the product out of the packaging and remove all packaging
materials and plastic wrappings.
2.
Check to make sure that all listed parts are included (see "Scope of
delivery").
3.
Check whether the product and all parts are in good condition, if any
damage or defect is detected, do not use the product, but follow the
procedure described in chapter "Warranty".
4.
Before first use, clean all parts of the product as described in the chapter
"Cleaning and care".
5.
Remove the protective film from the display
batteries.
Inserting/exchanging the batteries
Empty batteries can falsify the measured result.
When
appears in the display
9 ]
[
almost drained and must be replaced:
1. Switch off the product.
2. Open the battery compartment
3. Remove the used batteries.
4. Insert 3 batteries (LR03/AAA) into the battery compartment
Observe the correct polarity.
5. Close the battery compartment
NOTE: Do not press any button while changing the batteries.
. Insert the enclosed
[
3 ]
, the inserted batteries are
3 ]
[
.
17 ]
[
.
17 ]
[
.
17 ]
[
GB/IE
41
Need help?
Do you have a question about the PWM B2 and is the answer not in the manual?