KROHNE WATERFLUX 3070 Quick Start

Quick Start
WATERFLUX 3070
Battery powered electromagnetic water meter
Installation, assembly, start-up and maintenance may only be performed by appropriately trained personnel.
Check the nameplate for correct operating conditions.
This instrument complies with requirements of Low Voltage Directive. Instruments must not be connected to
power supply before reading instructions described in the manual.
The responsibility as to the suitability, intended use and corrosion resistance of the used materials against the
measured fluid of this device rests solely with the operator.
This device cannot be used in Hazardous Locations or Explosive Gas Atmospheres!
Lithium batteries are primary power sources with high energy content. If mistreated, they may present a potential
risk. The lithium batteries supplied, are non-rechargeable. Do NOT recharge the empty lithium batteries. Dispose
of them according the local legislation in your country.
To prevent damage to the Rilsan® coating, the WATERFLUX 3000 flow sensor must be installed carefully. Take
precautions during transport and installation to protect the in- and outlet of the flow sensor.
General
Check the device nameplate to ensure that the
device is delivered according to your order.
Check for damage
Device version(s)
Compact version Remote version
QS - WATERFLUX 3070 - 03/2024 - 4009956901- R04 en
Device nameplate (example)
Transport
- No special requirements
- Use the original packing of the device(s) when transporting
to the installation location.
For initial set up, we strongly recommend that you also refer to the relevant manual!
1 Installation
General installation requirements
Avoid vibration / Electromagnetic fields
3D
Inlet length:

2D

Inlet length: Depends on 2D/3D bends
upstream
 

Check the manual for more details on
installation options.
Lmax
Use sunshade
Lmin
Lmax - Lmin < 0.5 mm / 0.02"