Sensor Calibration (Ph, Orp, Ppm, Temperature) - Astralpool Control Connect-PH/ORP line Instruction Manual

24 Sensor Calibration (pH, ORP , PPM, TEMPERATURE)
Fast pH Calibration
'Fast' mode allows routine recalibration of the sensor when there are small errors in calibration with no need to remove the sensor or use
calibration solutions.
PROCEDURE:
1. Ensure that the sensor is immersed in water and that the filter system is running.
2. Use a pH kit to measure the existing pH of the water in the pool.
3. Follow the procedure shown in the pictures below:
pH
7.35
pH
7.35
7.30
123
ClmV
720
720
25.2
FLOW
OK
°C
12:15
pH Clppm Sens
/Cal/Fast
Without extract-
ing probe
7.00
Standard pH Calibration
'Standard' mode allows precise calibration of the sensor using two control solutions with pH 7.0 and pH 4.0. However, this requires that the
sensor be removed from the installation.
PROCEDURE:
IMPORTANT: Before closing the bypass valves, stop production by the equipment.
1. Remove the sensor from the probe holder and rinse it in an abundance of water.
2. Follow the procedure shown in the pictures below:
pH
pH
7.35
7.30
123
ClmV
720
720
25.2
FLOW
OK
°C
12:15
pH
/Cal/Standard
Wait
15 s
Clppm Sens pH Clppm
12
7.35
8.98
100%
pH
FLOW OK
pH: 6.0–9.0
CAL
pH Clppm Sens pH
/Cal/Fast /Cal/Fast
Without extract-
ing probe
7.25
pH Clppm
Clppm Sens
7.35 7.35
8.98
100%
pH
FLOW OK
pH: 6.0–9.0
CAL
Clppm Sens
pH Clppm
/Cal/Standard
CAL
16–60 s
Sens pH Clppm Sens
Bio pH-
/Config
Fast
P.STOP
Standard
INTEL
HYS 2s
Reset Cal
0 h
FUSE OK
Clppm Sens
Sens pH Clppm Sens
/Config
Fast
P.STOP
Standard
INTEL
HYS 2s
Reset Cal
0 h
FUSE OK
pH Clppm Sens
Sens
/Cal/Standard
CAL
16–60 s
49
pH Clppm Sens
/Cal/Fast
pH Clppm Sens pH Clppm
/Cal/Standard
/Cal/Standard
pH Clppm Sens
/Cal/Standard
Sens