2 Safety Warnings and Recommendations:
- Installation and manipulation should only be performed by proper-
ly-qualified technicians.
- Applicable standards for prevention of accidents and for electrical
installations must be respected. During installation, bear in mind that
electrically disconnecting the equipment requires a switch or circuit
breaker according to standards IEC 60947-1 and IEC 60947-3 which
ensures an omnipolar cut-off, directly connected to the power supply
terminals and with a contact separation in all poles, providing total
disconnection under overvoltage category III conditions, in an area that
fulfils the safety requirements of the site. The switch must be located in
the immediate vicinity of the equipment and must be easily accessible.
Additionally, it must be marked as the equipment's disconnection element.
- The equipment must be fed from a residual current device (RCD) not
exceeding 30mA.
- The manufacturer accepts no responsibility for assembly, installation or
setting up, nor for any manipulation or addition of components other than
when carried out at the manufacturer's premises.
- This appliance can be used by children aged 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack
of experience and knowledge, if they have been given supervision or
instruction concerning how to use the appliance safely and understand
the hazards involved. Children must not play with the appliance. Cleaning
and user maintenance must not be carried out by children without
supervision.
- If the power cable is damaged, it must be replaced by the manufacturer,
by the their after-sales service, or by equivalent qualified technicians in
order to avoid any type of danger.
- The control unit operates at 230 Vac / 50/60 Hz. Do not attempt to alter
the power supply to operate at any other voltage.
- Ensure that all electrical connectors are properly tightened, to avoid
bad connections leading to overheating.
24
Need help?
Do you have a question about the Control Connect-PH/ORP line and is the answer not in the manual?
Questions and answers