5
Slide the clips onto the right and left side of the power boxes and then place them into the center of the tabletop and press down to firmly
secure them. The power unit is installed properly when it is flush with the tabletop surface. *Note: If the table tops are not flush, loosen and
re-tighten the zipbolts as needed to ensure they are before you turn the table over.
1. SCREW THE BRACKET INTO THE UNDERSIDE OF THE TABLE, IN THE PATH OF THE CABLE
INSTALLING CABLE MANAGEMENT
7
Screw the bracket into the underside
of the table, in the path of the cable.
BRACKETS
2. PUSH THE VELCRO STRAP INTO THE SLOTS OF THE BRACKET
VELCRO STRAP
PHILLIPS HEAD WOOD SCREW
#10 X5/8"
Push the velcro strap into the slots of the bracket.
3. FASTEN THE CABLES WITH THE VELCRO STRAP
3. FASTEN THE CABLES WITH THE VELCRO STRAP
1. SCREW THE BRACKET INTO THE UNDERSIDE OF THE TABLE, IN THE PATH OF THE CABLE
2. PUSH THE VELCRO STRAP INTO THE SLOTS OF THE BRACKET
8
Fasten the cables with the velcro straps.
6
2. PUSH THE VELCRO STRAP INTO THE SLOTS OF THE BRACKET
Unroll and relax the kinks in the power cord. Then,
run it down the cable management slot provided in
the proper alternate leg.
3. FASTEN THE CABLES WITH THE VELCRO STRAP
Patent and trademark information: vari.com/patents ©2023 Varidesk, LLC All rights reserved.
Need help?
Do you have a question about the Executive Conference Table 4'x10' and is the answer not in the manual?