Advertisement
3
LEFT LEG
RIGHT LEG
The left, right, and alternate legs are labeled on the plate of each leg. (Center legs are labeled "AIM-A" and both should have a cutout for cable management). Align the square plate at the top of each leg with
the corresponding pre-drilled holes on the underside of the tabletop. Use the provided #12x1 Flat Head Phillips Screws and your power drill or Phillips Head screwdriver to secure them to the table, one by one.
*Note: It is only necessary to screw in the corners of each leg plate. There will be extra screws upon completion of this table.
LEFT LEG
4
With four or more people, turn the table to its side to rest on its legs. Then, turn it again to its upright position. *Note: We suggest placing the table near the power outlet you intend to
connect to before the next step.
CENTER LEG
RIGHT LEG
CENTER LEG
LEFT LEG
CENTER LEG
RIGHT LEG
RIGHT LEG
(AIM-RIGHT)
LEFT LEG
CENTER LEG
LEFT LEG
(AIM-A)
(AIM-LEFT)
CENTER LEG
RIGHT LEG
Advertisement
Need help?
Do you have a question about the Executive Conference Table 4'x10' and is the answer not in the manual?