Other Functions: Dpf1C; Procedure; Switch Between Cm And Inchl; Adjusting The Light Intensity Of The Led Display - Linak DESKLINE DPF 1C User Manual

Other functions: DPF1C

Adjusting initial height:
It may be necessary to adjust the displayed height due to diff erent thicknesses of desktops etc.
The DPF1C will as standard show either 68cm or 24.5 inch as the default
desk height.

Procedure:

Press /\ and \/ keys at the same time and keep them pressed for 5 seconds. This allows the initial height to
be adjusted. Until the initial height can be adjusted, the display will show three minuses (---) - hereafter the
display will revert to showing the height. The height can then be adjusted by either /\ or \/ until the desired
height has been reached. The system will return to normal operation (and give a short blink) after 5 seconds of
inactivity on the keys.
The feature can be disabled via confi guration in which case pressing the /\ and \/ keys at the same time will be
considered an illegal keypress.
Switch between cm and inch:
Switching between cm and inch can only be done via the DPF1C confi gurator.

Adjusting the light intensity of the LED display:

Possible settings are Off , 6%, 12%, 19%, 25%, 37%, 50%, 75% and 100%.
The adjustment can only be done via the DPF confi gurator.

Adjusting the light timeout:

Possible settings are 0-15 seconds and Off .
The adjustment can only be done via the DPF1C confi gurator.
12/38 EN 114065
EN

8. ERROR CODES

Below please fi nd the possible error codes that can be displayed. The error codes will only be displayed when
a button is pressed. The display will blink while showing the error code. The E16 error will overrule any other
errors as the detection is registered only in the display and no message is send to the control box.
Error no. Description
E01 The desk has an unknown position and needs to be initialised.
E02 Overload in upward direction has occurred.
E03 Overload in downward direction has occurred
E16 Illegal keys are pressed.

9. MOUNTING

The DPF must be mounted via a mounting bracket.
Mounted on the edge of the table top.
The panel is mounted with a 45° bracket
Mounting bracket
13/38 EN 114065
EN