Replacement; Historom; Return; Disposal - Endress+Hauser Liquiphant FTL63 Operating Instructions Manual

Liquiphant FTL63 HART
Endress+Hauser
13.3

Replacement

CAUTION
L
Data upload/download is not permitted if the device is used for safety-related
applications.
‣
After an entire device or an electronics module has been replaced, the parameters can
be downloaded to the device again via the communication interface. For this, the data
must have been uploaded to the PC beforehand using the "FieldCare/DeviceCare"
software.
13.3.1

HistoROM

It is not necessary to perform a new device calibration after replacing the display or
transmitter electronics.
The spare part is supplied without HistoROM.
After removing the transmitter electronics, remove HistoRom and insert it into the
new spare part.
13.4

Return

The requirements for safe device return can vary depending on the device type and
national legislation.
1. Refer to the web page for information:
https://www.endress.com/support/return-material
 Select the region.
2. If returning the device, pack the device in such a way that it is reliably protected
against impact and external influences. The original packaging offers the best
protection.
13.5

Disposal

If required by the Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE), the product is marked with the depicted symbol in order to
minimize the disposal of WEEE as unsorted municipal waste. Do not dispose of
products bearing this marking as unsorted municipal waste. Instead, return them to
the manufacturer for disposal under the applicable conditions.
14

Accessories

14.1

Device Viewer

All the spare parts for the device, along with the order code, are listed in the Device Viewer
(www.endress.com/deviceviewer).
14.2 Weather protection cover for dual compartment
housing
• Material: stainless steel 316L
• Order number: 71438303
Accessories
49