Page 1
Installation and start up instructions Electronic potentiometer type EPN-110DN uni-line 4189340132G (UK) • Control of electronic governors • Setting of integrating time • Adjustment of output signal • Offset adjustment • LED indication for activated input • 35 mm DIN rail or base mounting...
Page 2
The EPN-110DN is an electronic unit to replace normal motor potentiometers, converting the relay output of a PI step controller – e.g. one of the DEIF load sharing units type LSU… or one of the DEIF synchronisers type FAS…, or any other type of PI step controller provided with relay outputs –...
Page 3
For 3 point connections mounting the normally applied external potentiometer is recommended, and then to connect the EPN-110DN in series with the wiper of the potentiometer for the speed governor/AVR. The relay contacts shown in On activation of Relay contact...
Page 4
“x10”). To obtain a stable control, the setting of the “OUTPUT” potentiometer should ensure that overcontrol of the connected speed governor/AVR will not occur. When connecting the EPN-110DN to the speed governor/AVR, the normal set point of this will normally be slightly changed, which may be corrected by adjusting the “OFFSET”...
Need help?
Do you have a question about the EPN-110DN and is the answer not in the manual?
Questions and answers