Page 1
INSTRUCTION MANUAL DSSM Digital Wireless Water-Resistant Micro Body Pack Transmitter DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 IP57 Watertight Fill in for your records: Serial Number: Purchase Date: Rio Rancho, NM, USA www.lectrosonics.com...
Page 2
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 LECTROSONICS, INC.
Water-Resistant Micro Body Pack Transmitter Table of Contents Introduction ......................................4 What Is IP57? ......................................4 600 MHz Guard Band and the Duplex Gap ............................5 Battery Installation ....................................5 Controls and Functions ..................................6 Modulation LEDs ....................................6 OLED Screen ......................................6 BATT LED ......................................6 MENU/SEL Button ....................................6 Power Button .......................................6 UP and DOWN Arrow Buttons................................6 Encryption Status LCD/LED Indicator Modes ............................6...
The housing is constructed of machined aluminum alloy, performance packed into an exceptionally compact treated in the conductive, super hard electroless nickel housing, compatible with all current Lectrosonics digital ebENi finish. receivers, including the DSR, DSR4, DSQD, DCR822, A flexible, repositionable wire belt clip (to orient the an- M2Ra and DCHR.
Press both release ment. catches inward to open. CAUTION: Use only the Lectrosonics LB50 battery and Lectrosonics battery chargers. WARNING: Risk of fire or explosion if the battery is replaced by an incorrect type.
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 Controls and Functions The exact point at which the LED turns red will vary with Operating BATT LED temperature and current drain. The LED is intended to Modulation Mode Encryption simply catch your attention, not to be an exact indicator...
Water-Resistant Micro Body Pack Transmitter Turning LEDs ON and OFF (Shortcut) From the main “home” screen, the arrow keys also turn the LEDs on and off. With LEDs no other button pressed, the arrow turns the LEDs on and the arrow turns them off.
RF output of the transmitter is turned off. Stand- the transmitter for normal use. by Mode means no transmission. 1) Install a charged Lectrosonics LB-50 battery or retrieve the charged unit from the charging dock. 564.800 2) Set the compatibility mode to match the receiver...
Water-Resistant Micro Body Pack Transmitter Locking the Controls The controls can be locked by going to MENU, then 5) Once the audio gain has been set, the signal can SETUP. Use the arrow buttom to scroll down to be sent through the sound system for overall level Locked? Use the UP and DOWN arrows to choose, then adjustments, monitor settings, etc.
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 Menu Map Main Menu Tree Use arrow buttons to increase or decrease gain G a i n G a i n to select I n p u t BACK and return | - 4 0 | - 2 0 + 0 |...
Page 11
and return Scroll option with arrow buttons K e y T y p e Key Type options are Water-Resistant Micro Body Pack Transmitter to select K e y T y p e Universal, Standard, BACK and return Shared, and Volatile. S t a n d a r d Toggle option with arrow buttons This menu choice is...
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 Menu Screen Details 3) Prepare the signal source. Position a microphone the way it will be used in actual operation and have the user speak or sing at the loudest level that will Top Menu...
Bias RF transmission can be turned on or off using the Same as Oth Lav; arrow buttons. for easy selection M152 MicLowZ Positive of Lectrosonics 152 and similar Xmit... R f O n ? Xmit Menu Freq......
..........Sync --> be generated. Simply set the Lectrosonics encryp- GetFreq tion-capable transmitters and receivers to Univer- sal key type, and the encryption is in place. This allows for convenient encryption amongst multiple NOTE: SendAll does not send Encryption Key.
Water-Resistant Micro Body Pack Transmitter • Shared: This key policy is designed for sports cov- Remote erage and similar applications where a unique key Press MENU/SEL to toggle the remote “dweedle tone” provides enhanced security, but multiple transmit- ters and receivers can share the same key. Once feature on or off.
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 Microphone Wiring Default Press MENU/SEL to restore the Default (factory) set- Looking into the 3 pin Lemo mic connector from the out- tings. side of the transmitter, the pin centered in the two guide slots is pin 1 (ground). Pin 2 is a 1k resistor to ground.
Water-Resistant Micro Body Pack Transmitter Selecting Mic/Audio Input Configuration Whip Antennas Refer to Page 12 for detailed information on configuring Because the transmitter tunes across such a broad Line and Instrument level inputs. frequency range, it is best to use the appropriate antenna for maximum operation.
LectroRM is a 3rd party mobile application for iOS and Android smart phone operating systems. Its purpose is to make changes to the settings on select Lectrosonics transmitters by delivering encoded audio tones to the microphone attached to the transmitter. When the tone...
When finished, unplug the unit, replace Firmware files are located at https://lectrosonics. the battery, and power on to RF Off mode, and check the com/firmware.html and Wireless Designer software firmware version in Setup>About to verify the update.
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 Optional Accessories Supplied Accessories CHSDSSM Dock Charging System AMM19 Charger for two Lectrosonics LB-50 batteries; includes Whip Antenna with Standard SMA Connector. Block 19; charger and short USB cable. Use P/N 40117. included with A1B1 variant only. AMM22 Available with transmitter as a kit.
FCC RF exposure guidelines when DSSM/E07-941: 941.525 - 951.575 953.025 - 956.225 used with the Lectrosonics accessories 956.475 - 959.825 supplied or designated for this product. Use of other accessories may not ensure Frequency...
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 Troubleshooting It is important that you follow these steps in the sequence listed. Symptom: Possible Cause: Transmitter Battery LED off 1. Batteries are inserted incorrectly. when Power Switch “ON” 2. Batteries are low or dead.
There are no adjustments inside that will make a malfunctioning unit start working. LECTROSONICS’ Service Department is equipped and staffed to quickly repair your equipment. In-warranty repairs are made at no charge in accordance with the terms of the warranty. Out-of-warranty repairs are charged at a mod- est flat rate plus parts and shipping.
Page 24
DSSM-A1B1, DSSM-B1C1, DSSM/E01-A1B1, DSSM/E01-B1C1, DSSM/E07-941 LECTROSONICS, INC.
Page 25
Water-Resistant Micro Body Pack Transmitter Rio Rancho, NM...
Page 26
This warranty does not apply to used or demonstrator equipment. Should any defect develop, Lectrosonics, Inc. will, at our option, repair or replace any defective parts without charge for either parts or labor. If Lectrosonics, Inc. cannot correct the defect in your equipment, it will be replaced at no charge with a similar new item.
Need help?
Do you have a question about the DSSM-A1B1 and is the answer not in the manual?
Questions and answers