Omron H5S Datasheet page 17

Cyclic Operation
Weekly, 2 Circuits Yearly, 2 Circuits
Example: ON for 5 minutes and OFF for 1 hour 55 minutes
repeatedly from 8:00 to 19:00 on Sunday.
Start
5 min
1 h 55 min
8:00
1. Set the Mode Switch to P1 or P2. *1
(The Time Switch enters program
setting mode.)
→ For 4-circuit models, refer to
page 18.
TIMER
P1
P2
PULSE
RUN
2. Press CYCLE .
(The Time Switch enters cyclic
program setting mode.)
3.
Press the Day Keys to turn ON the bar
( ) at the Sunday position.
with
Set the start time to 8:00
m . *2
4. Press WRITE .
Set the stop time to 19:00 with
and m . *2
5. Press WRITE .
Set the ON time period with
m
. *2
6. Press WRITE .
Set the OFF time period with
m . *2
7. Press to enter the settings.
WRITE
*1 If one or more programs have already been set, the display starts
showing the set programs.
To add another program, press
is displayed.
*2 Holding down the h and m
Pressing decrements the value of the key that was last
pressed.
Yearly, 4 Circuits
SUN
Stop
19:00
Number of
Shaded portion
remaining steps
indicates blinking of
the indicator.
SUN MON TUE WED THU FRI SAT
SUN MON TUE WED THU FRI SAT
h and
SUN MON TUE WED THU FRI SAT
h
SUN MON TUE WED THU FRI SAT
h and
SUN MON TUE WED THU FRI SAT
h and
SUN MON TUE WED THU FRI SAT
WRITE repeatedly until "--:--"
Keys rapidly advances the value.
Note:
• If multiple settings are required, repeat steps 2 through 7.
• All the start/stop times, and ON/OFF time periods must be set.
• All of the weekly programs for the selected circuit (output) can be
checked by pressing WRITE
• When the Mode Switch is set to P1 or P2 (to PRGM for 4-circuit
models), the Time Switch stops automatic operation. To forcibly
turn ON or OFF the output, use the Output ON/OFF Switches.
• Set cyclic operation so as not to overlap other operations in
individual circuits.
• The set data will be cleared if the Output Setting Switch is moved
between the TIMER and PULSE positions after the data has been
set.
Digital Time Switch
in program setting mode.
H5S
17