Common To All Timers; Installation Of Screw-Less Clamp Models - Omron H3DS Manual

Installation of Screw-Less Clamp Models

■ Tools
A flat-blade screwdriver should be used to mount the cables.
Applicable Screwdriver
● Flat-blade, Parallel-tip, 2.5 mm diameter
• Flat-blade, Parallel-tip
• Flat-blade, Flared-tip
Examples: FACOM AEF.2.5 75E
VESSEL No. 9900-(-)2.5
WAGO 210-119
WIHA 260/2.5 40
■ Applicable Wires
Applicable Wire Sizes
2
0.2 to 1.5 mm , AWG24 to AWG16
Applicable Wire Type
Solid wires, stranded wires, flexible wires, or wires with ferules can
be used.
(See note 1) < 1.8 Diameter D (mm)
Conductor diameter d (mm) or length of sides a and b (mm)
Wires with Ferules
Note: 1. If the overall diameter of the wire is less than 1.8 mm, do not
insert the wire past the conductor. Refer to the following di-
agrams.
OK
2. If the overall diameter of the wire is over 2.8 mm, it will be
difficult to use double wiring.
2.5 dia.
Cannot be used.
75
3.0 (see note 2)
1.6
NG
H3DS-@LC

Common to All Timers

B-45