Omron H3DS Manual page 32

Specifications
■ General
Item
Operating mode
Operating/Reset method
Output type
External connections
Terminal block
Terminal screw tightening torque
Mounting method
Attachment
Approved standards
Note: Can be mounted to 35-mm DIN Track with a plate thickness of 1 to 2.5 mm.
■ Time Ranges
Time scale display
0.1 s
1 s
0.1 m
1 m
0.1 h
1 h
10 h
Note: When the time setting dial is set to "0" for any time scale, the output will operate instantaneously.
■ Ratings
Rated supply voltage (see note)
Operating voltage range
Power reset
Reset voltage
Reset current
Power consumption
Control output
Ambient temperature
Ambient humidity
Note: The ripple in DC power supply must be 5% max.
B-40
Solid-state Two-wired Timer
ON-delay
Time-limit operation/self-resetting
SCR output
Screw terminal, Screw-Less Clamp
Screw terminal type: Clamps two 2.5-mm
Screw-Less Clamp type: Clamps two 1.5-mm
0.98 N·m max.
DIN track mounting (see note)
Nameplate label
UL508, CSA C22.2 No.14
Conforms to EN61812-1, IEC60664-1 4 kV/2, VDE0106/P100
Time range
0.1 to 1.2 s
1 to 12 s
0.1 to 1.2 min
1 to 12 min
0.1 to 1.2 h
1 to 12 h
10 to 120 h
24 to 230 VAC/VDC (50/60 Hz)
85% to 110% of rated supply voltage
Minimum power-off time: 0.1 s
1.0 VAC/VDC max.
5 mA max.
5 mA max.
SCR output:5 mA to 0.7 A
Operating: –10 C to 55 C (with no icing)
Storage: –25 C to 65 C (with no icing)
Operating: 35% to 85%
H3DS-X
H3DS-X
2
max. bar terminals without sleeves.
2
max. bar terminals without sleeves.