Setting Level Configuration And Key Operations - Omron E5 Getting Started Manual

Setting Level Configuration and Key Operations

1-3

Setting Level Configuration and Key Operations

Start in manual mode.
Start in automatic mode.
Press the O Key or the
PF Key for at least 1 s.
(See note 4.)
a-m
Press the O Key
(See
for at least 3 s while
Manual
a-m is displayed.
note
mode
(a-m will flash after
3.)
1st second.)
Press the PF Key
Manual
for at least 1 s.
Control Level
Control stops.
Note: Not described in this manual.
Please refer to H156
12
Parameters are divided into groups, each called a level. Each of the set val-
ues (setting items) in these levels is called a parameter. The parameters on
the E5CN/CN-U/AN/EN/GN are divided into the following 9 levels.
When the power is turned ON, all of the display lights for approximately one
second.
Power ON
Operation
Level
PF Key
(See note 5.)
(See note 4.)
(See
note 1.)
Press the
O Key for
at least 1 s.
Initial Setting
Level
Press the O Key
for at least 1 s.
Advanced Function
Setting Level
Calibration Level
Note (1) You can return to the operation level by executing a software reset.
(2) You cannot move to other levels by operating the keys on the front panel
from the calibration level. You must turn OFF the power supply.
(3) From the manual control level, key operations can be used to move to the
operation level only.
Protect level
Operation level
Adjustment level
Manual control level
Monitor/setting item level
Initial setting level
Adjustment
Level
Press the
O Key less than 1 s.
PF Key
(See note 5.)
Monitor/Setting
Item Level
Press the O Key for at
least 3 s. (Display will flash
25
c
after 1st second.)
100
Communica-
tions Setting
Level
Press the
O Key for less than 1 s.
Input password while
amoV is displayed. (Set
value −169)
Input password.
(See
note 2.)
Level Control in progress
Can be set.
Can be set.
Can be set.
Can be set.
Can be set.
---
Section 1-3
Press the
O+ M
Press the Keys for at
O+ M
least 1 s.
Keys for at
least 3 s.
25
c
(Display
will flash
100
after 1st
second.)
Protect Level
Note The time taken to move
to the protect level can
be adjusted by chang-
ing the "Move to pro-
tect level time" setting.
Control in progress
Control stopped
Not displayed for some models
Level change
Control stopped
---
---
---
---
---
Can be set.