Synchronizing A Transmitter With The Receiver - Sennheiser Rack-mount Receiver EM 300 G3 Instruction Manual

Using the receiver
22

Synchronizing a transmitter with the receiver

You can synchronize a suitable transmitter of the ew 300 G3 series with
the receiver. If the receiver is in ex works condition, the following parame-
ters are transferred to the transmitter during synchronization:
Setting
"Frequency Preset" Currently set frequency
"Name"
"Pilot Tone"
Via the "Sync Settings" submenu, you can adjust the parameters to
be transferred to your transmitters (see page 39). It is vital to
observe the notes on frequency selection on page 44.
To transfer the parameters:
Switch the transmitter and the receiver on.
»
Press the button
"Sync" appears on the display panel of the receiver.
Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface
receiver.
The parameters are transferred to the transmitter. When the transfer
is completed, " " appears on the receiver's display panel. The receiver
then switches back to the current standard display.
Transferred parameters
Freely selectable name currently set on the receiver
Current pilot tone setting of the receiver
("Inactive"/"Active")
on the receiver.
»
of the