Organize it System – Double Wall Frame
ASSEMBLY & MOUNTING INSTRUCTIONS
Parts Included:
(A) Side and Middle Members – 3 pcs
Hardware Included:
(D) Screw – 18 pcs
Tools Required:
Assembling Instructions:
1.
Position the two Side Members (A) onto a flat surface so
that they are parallel to each other and about 36 inches apart.
Position the middle member in the middle. Each bar must be
facing down so that the rear surface is showing. You should see
8 holes on each. These will be the left and right sides of the
supporting frame. Securing screws will pass through select
holes on this rear surface and into bars located on the opposing
side, as described below.
2.
Now position a Top Frame Rail (B) (the one with the two blocks
near each end) UNDER the two Side and Middle Members (A)
so that the top surface of each block is
surface of each Side Member, as shown. Use the provided
screws (D) to secure each end of the Top Frame Rail (B) to the
upper end of each Side and Middle Member (A). Each screw (D)
should pass through the UPPERMOST hole of each Side and
Middle Member (A) and into the aligned threaded hole of each
Top Frame Rail (B). Use a screwdriver to tighten each screw
until tight.
3.
Repeat Step (2) with the Bottom Frame Rail (B) so that the this
rail is secured to the Side and Middle Members using the
LOWERMOST holes of the Side and Middle Members (A).
The hardware included is meant for drywall or wall stud mounting.
If your walls are concrete, brick, or plaster, we recommend that
you consult your local hardware store to determine the proper
hardware for your wall type.
(E) Anchors - 6 pcs
Philips Screwdriver, Level, Pencil, Stud-Finder
(B) Top / Bottom Frame Rails
(with Blocks) – 2 pcs
even with the top
(C) Support Rails – 4 pcs
(F) Stud Mounting Screws - 6 pcs
Need help?
Do you have a question about the Organize it System Double Wall Frame and is the answer not in the manual?
Questions and answers