PB TEEN Oxford Bedside Assembly Instruction

Oxford Bedside
Assembly Instruction

Pre-Assembly:

Please read all instructions before beginning assembly.
•
For your safety and convenience, assembly by two adult is recommended.
•
Carefully set out and identify all part hardware prior to assembly.
•
Save all packing materials until assembly is complete to avoid accidentally discarding small
•
part or hardware.

Parts Enclosed:

• (1) Storage (A)
• (2) Side panel (B)
• (1) Bottom Shelf (C)

Hardware Enclosed:

• (4) Allen Bolts M6 x 45mm (D)
• (8) Allen Bolts M6 x 25mm (E)
(4) Spring Washers (F)
•
• (4) Half Moon Bracket (G)
• (1) Allen Key M4 (H)
• (4) Screw M6 x ¾" (I)

To Assemble:

1. Remove the drawer from the storage (A), as shown in figure 1.
2. Carefully lay the storage (A) upside down on a flat scratch-free or carpeted surface. Attach
the side panel (B) by aligning wooden dowels on the storage (A) to the holes on the side panel
(B). Insert Allen bolts (E) through the holes on the side panels of the storage (A) into the
inserts on the side panel (B). Tighten with the Allen key (H) (Do not over tighten), as shown
in figure 2, illustration 1.
Fig.1
A
3. Attach the bottom shelf (C) by aligning the dowels on the bottom shelf (C) to the holes on the
post. Place half-moon bracket (G), spring washers (F) onto the Allen bolts (D) to the cutout
of the bottom panel. Tighten with Allen key (H) as shown in figure 3, illustration 2. (Do not
over tighten)
Fig.3
(D) (E)
(G) (H)
Fig.2
B
(F)
(I)
Illustration.1
Illustration.2