Trouble Shooting And Information - Ferguson FDT 2000 DIGITAL TERRESTRIAL RECEIVER Manual

8510 FDT2000 Rev2 inc scart
TROUBLE SHOOTING AND
TECHNICAL INFORMATION
Trouble Shooting
Not every picture or sound problem is caused by a defect in your Digital
Terrestrial Receiver. Leads having been accidentally pulled out or worn out
batteries in the remote control can also cause impairment.
If the following measures do not bring about satisfactory results, consult an
authorised dealer.
FAULT
Receiver does not
respond to the
remote control
No Picture
Disrupted Picture
No Sound
No Power
Technical Information
This product fulfils the European directives 89/336/EEC, 73/23/EEC and
93/68/EEC. This device conforms to the safety regulation DIN EN 60065 (VDE
0860) and therefore the international safety regulation IEC 60065.
You may not open the Digital Terrestrial Receiver. The manufacturer accepts no
liability for damage resulting from improper handling
Mains voltage:
230V~, 50/60Hz
Ambient temperature:
+10°C to 35°C
Dimensions and weight
Dimensions : W x H x D - 252 x 43 x 153mm
Weight : Approx. 0.7Kg
Video:
Signal to noise : 73dB
Video jitter : 1ns
14
17/2/03 6:27 pm Page 14
CAUSE/REMEDY
Unit is in low power standby. Press Standby button on unit.
Point the remote control directly at the receiver.
Remove all obstacles which may impair the path of the
remote control signal.
Check or replace the remote control batteries.
Check all connections at the rear of the unit
Check RF IN connection. Ensure cables to TV are inserted
correctly
Select AV channel on TV set
Replace aerial outlet plate with shielded type
Check all connections at rear of unit
Check mains plug is inserted correctly and receiver is
switched on
Power consumption:
Operating ~10W. Low power standby <
Audio Format:
Analogue : Stereo Sound
Audio:
Signal-to-noise : 95dB
Interchannel isolation : 90dB
THD : 0.03%
1 /
W
2