Timer Programming And Recording - Ferguson FDT 2000 DIGITAL TERRESTRIAL RECEIVER Manual

8510 FDT2000 Rev2 inc scart
TIMER PROGRAMMING AND
RECORDING
To record an analogue channel ensure that the aerial connections to your VCR
are as shown in the connection diagram and use the VCR as normal.
To record a digital channel, connect the receiver directly to your VCR via the
VCR scart socket on the rear of the receiver (see connection diagram). Please
consult your VCR user manual for details on recording via AV or AUX inputs.
For RF recordings select tuned channel on the VCR.
The TIMER PROGRAMMING function enables the receiver to :-
NOTE: The system may not accept a start time less than 5 minutes ahead of
the current clock time displayed in the menu.
G
G
If a mistake has been made during DETAIL ENTRY, an error message will be
displayed at the bottom of the screen. For instance, in the event of 2
programmes being entered with similar start times, then an EVENT CLASH
error message will be displayed. If any errors are found during this stage, the
system will not allow any further progress.
When the Timer Event has been activated, both RED and GREEN LEDs will be
lit for the duration of the event. A suitably equipped VCR will record
automatically during this time. Please note that unless your VCR supports
automatic scart recording YOU MUST ALSO SET THE VCR TIMER.
In order to delete an entry you no longer need, position the cursor over the
entry to be removed in the TIMER PROGRAMMING menu and press
10
Cancel an event at any time by pressing
17/2/03 6:27 pm
Automatically switch to your pre-selected channels at
G
pre-selected times.
Start Auto Record on the VCR (where the VCR supports scart
G
automatic recording function, see your VCR manual for details
on this.)
1. Press , select TIMER PROGRAMMING and press
.
2. Using L / M select a free event, or select an event you
wish to alter and press
3. Using /
use 0..9 to enter the number directly, e.g. 003.
4. Press M to select the date and enter the date directly
G
Back Quit
using 0..9 or use
5. Press M to select the time and enter the start time
directly using 0..9 or use
6. Press M to select the duration and enter the length of
the program using 0..9 or use
7. Press M to select repeat. Press
WEEKLY, DAILY, MON-FRI, MON-SAT or NO.
8. Press M to select subtitles. Press
G
Back Quit
NO.
9. When the details are correct, press
them.
10. To exit menu, press
Page 10
.
select the program you wish to record or
to choose.
/
/
to choose.
to choose.
/
to choose from
to choose YES or
.
. Press again to confirm.
to store
red.