Ferguson  FDT 2000 DIGITAL TERRESTRIAL RECEIVER Manual

Ferguson FDT 2000 DIGITAL TERRESTRIAL RECEIVER Manual

Digital terrestrial receiver

Advertisement

8510 FDT2000 Rev2 inc scart
17/2/03 6:26 pm
Page 1
DIGITAL TERRESTRIAL
RECEIVER
FDT 2000

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FERGUSON FDT 2000 DIGITAL TERRESTRIAL RECEIVER and is the answer not in the manual?

Questions and answers

Summary of Contents for Ferguson FERGUSON FDT 2000 DIGITAL TERRESTRIAL RECEIVER

  • Page 1 8510 FDT2000 Rev2 inc scart 17/2/03 6:26 pm Page 1 DIGITAL TERRESTRIAL RECEIVER FDT 2000...
  • Page 2: Table Of Contents

    8510 FDT2000 Rev2 inc scart 17/2/03 6:26 pm Page 2 CONTENTS Accessories Safety Information Connections Remote Control Handset Tuning the Receiver Advanced Setup Program Information Lists and interactive services Timer Programming and Recording Parental Controls Upgrading your Receiver Other Information...
  • Page 3: Safety Information

    G Do not expose the receiver to any moisture. The receiver is intended for use in dry rooms. If you wish to operate it in the open air, make absolutely sure that it is protected against moisture (rain, splashes, etc.).
  • Page 4: Connections

    THROUGH HI FI AUX IN 1. Connect the cable of your TV aerial to the »RF IN« socket on the rear of the receiver. 2. Connect scart and other cables as shown in the diagram above. It is strongly recommended that the product be connected via scart...
  • Page 5: Remote Control Handset

    8510 FDT2000 Rev2 inc scart 17/2/03 6:27 pm Page 5 REMOTE CONTROL Insert the batteries into the handset making note of the polarity. Always point the remote control at the receiver. The remote control Switches the receiver in/out of stand-by mode.
  • Page 6: Tuning The Receiver

    Page 6 TUNING THE RECEIVER Start up Once the mains has been connected to the receiver, it will take up to15 seconds to start up. If this is the first time installation, a menu will automatically appear. Press when prompted.
  • Page 7: Advanced Setup

    Full Frame (stretched). 5. Use to turn the RF Modulator On or Off. 6. The Modulator Channel is set by the factory to CH22. If you wish to change the channel you tune your TV to (in order to avoid interference), use to adjust it.
  • Page 8: Program Information

    Page 8 PROGRAM INFORMATION TV guide The TV guide shows details of programs whilst allowing you to watch a smaller picture of the selected service. To access the guide press Move up and down the channel listings using L / M keys, you can move a page at a time by using Pr+/Pr- keys.
  • Page 9: Lists And Interactive Services

    Service List This list contains all the services that were tuned in during an Auto tune or Manual tune. You can delete services that you do not want or you can add them to your Favourite List for easier selection.
  • Page 10: Timer Programming And Recording

    Start Auto Record on the VCR (where the VCR supports scart automatic recording function, see your VCR manual for details on this.) NOTE: The system may not accept a start time less than 5 minutes ahead of the current clock time displayed in the menu. 1. Press , select TIMER PROGRAMMING and press 2.
  • Page 11: Parental Controls

    You can use PARENTAL CONTROL to create viewing restrictions on your receiver. First create your own Personal Identification Number (PIN) as shown in the Advanced Setup section of this guide. You can now create censorship levels or Lock out channels completely.
  • Page 12: Upgrading Your Receiver

    Check for download You can manually check to see if new software is available for download. If there is one available, you will see the download menu as above. To check:- 1.
  • Page 13: Other Information

    In this mode you must use the button on the front of the unit to switch it back on. This returns the unit to normal standby and you can now use the remote control as normal. This low power standby mode will also interrupt the aerial signal, making analogue TV viewing or recording impossible.
  • Page 14: Trouble Shooting And Information

    TROUBLE SHOOTING AND TECHNICAL INFORMATION Trouble Shooting Not every picture or sound problem is caused by a defect in your Digital Terrestrial Receiver. Leads having been accidentally pulled out or worn out batteries in the remote control can also cause impairment.
  • Page 15 8510 FDT2000 Rev2 inc scart 17/2/03 6:27 pm Page 15...
  • Page 16 8510 FDT2000 Rev2 inc scart 17/2/03 6:27 pm Page 16 THOMSON sales UK 30 Tower Hill West Malling Kent ME19 4NQ http://www.thomson-europe.com 3569851000...

This manual is also suitable for:

Grundig gdt2000 set top box freeviewFdt 2000

Table of Contents