Simons Voss Technologies RouterNode 2 Manual page 26

RouterNode 2 (Manual)
Reset network configuration
1. Disconnect the power supply (round plug or network cable for PoE).
2. Wait 20 seconds.
3. Press and hold the reset button.
4. Reconnect the power supply (round plug or network cable for PoE).
5. Release the reset button after five seconds.
Device flashes green again (see
9
9 Network configuration is reset.
NOTE
Unauthorised access with standard access data
The standard access data can be viewed freely. Unauthorised persons can-
not change the access authorisations, but they can change the network
configuration. You will then no longer be able to reach the device via the
network and will have to reset it.
Some browsers do not transmit spaces at the beginning of the password.
1. Change the default password.
2. Do not start or end the password with spaces.
You receive the device with the following factory configuration:
IPaddress
User name
Password
The IP address of your device on your network can be determined using the
free OAM tool ( https://www.simons-voss.com/de/downloads/software-
downloads.html ). Please refer to the manual for more information.
12. Fault rectification
Signalling [ 24] ).
}
192,168,100,100
SimonsVoss
SimonsVoss
26 / 34