Table of Contents
Advertisement
Product Overview
Specifications
Cutting Unit
27 inch, 5 blade
27 inch, 8 blade
27 inch, 11 blade
32 inch, 8 blade
Attachments/Accessories
A selection of Toro-approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro genuine
parts. When it comes to reliability, Toro delivers replacement
parts designed to the exact engineering specification of our
equipment. For peace of mind, insist on Toro genuine parts.
Weight
57 kg (125 lb)
60 kg (132 lb)
62 kg (136 lb)
67 kg (147 lb)
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Making Adjustments
Adjusting the Bedknife to the Reel
Use this procedure to set the bedknife to the reel and to check
the condition of the reel and bedknife and their interaction.
After completing this procedure, always test the cutting
unit performance under your field conditions. You may
need to make further adjustments to obtain optimal cutting
performance.
Important: Do not overtighten the bedknife to the reel
or you will damage it.
•
After backlapping the cutting unit or grinding the reel, you
may need to mow with the cutting unit for a few minutes
and then perform this procedure to adjust the bedknife to
the reel as the reel and bedknife adjust to each other.
•
You may need additional adjustments if the turf is
extremely dense or your cutting height is very low.
You will need the following tools to complete this procedure:
•
Shim 0.0508 mm (0.002 inch)—Toro Part No. 125-5611
•
Cutting performance paper—Toro Part No. 125-5610
1. Position the cutting unit on a flat, level work surface.
Turn the bedbar-adjusting screws counterclockwise
to ensure that the bedbar does not contact the reel
(Figure
11).
1. Bedbar-adjusting screw
2. Tip the cutting unit to expose the bedknife and the reel.
Important: Ensure that the nuts on the back end
of the bedbar-adjusting screws are not resting on
the work surface; use the kickstand
7
Figure 11
(Figure
g003322
12).
Advertisement
Table of Contents
