Connecting The Cables - Check Point QUANTUM SPARK 1900 Getting Started Manual

Connecting the Cables

1. Connect the power cord.
Note - Quantum Spark 1900 / 2000 appliances have 2 power cords for
redundancy. You do not need to connect both cords.
2. When the appliance is turned on, the Power LED on the front panel lights up in red for a
short period.
The LED then turns blue and starts to blink. This shows a boot is in progress and
firmware is being installed.
When the LED turns a solid blue, the appliance is ready for login.
Note - The LED is red if there is an alert or error.
3. Connect the standard network cable to the LAN1 port and to the network adapter on your
PC.
4. If you use an external modem:
Connect the Ethernet cable to the WAN port on the appliance back panel and plug it into
your external modem or router's PC/LAN network port. The Internet LED on the
appliance front panel lights up when the Ethernet is connected.
Note - Wait 10 seconds between power cycles (off and on).
Quantum Spark 1900 / 2000 Appliance Getting Started Guide | 10
Connecting the Cables