Administrator Access - Check Point QUANTUM SPARK 1900 Getting Started Manual

Administrator Access

In the Administrator Access page, configure if administrators can use the appliance from a
specified IP address or any IP address.
To configure administrator access:
1. Select the sources from where administrators are allowed access:
n LAN - All internal physical ports.
n Trusted wireless - A known wireless network.
n VPN - Using encrypted traffic through VPN tunnels from a remote site or using a
remote access client.
n Internet - Clear traffic from the Internet (not recommended).
2. Select the IP address from which the administrator can access the appliance:
n Any IP address.
n Specified IP addresses only - Select this option to let administrators access the
appliance from a specified IP address or network. Click New to configure the IP
address information.
n Specified IP addresses from the Internet and any IP address from other
sources - Select this option to allow administrator access from the Internet from
specific IP addresses only and access from other selected sources from any IP
address. This option is the default.
To specify IP addresses:
1. Click New.
2. In the IP Address Configuration window, select an option:
n Specific IP address - Enter the IP address or click Get IP from my computer.
n Specific network - Enter the Network IP address and Subnet mask.
3. Click Apply.
Quantum Spark 1900 / 2000 Appliance Getting Started Guide | 27
Administrator Access