Connecting The Cables - Check Point QUANTUM SPARK 1600 Getting Started Manual

Connecting the Cables

1. Connect the power cord.
Note - Quantum Spark 1800 appliance has 2 power cords and both must be connected.
2. When the appliance is turned on, the Power LED on the front panel lights up in red for a short period.
The LED then turns blue and starts to blink. This shows a boot is in progress and firmware is being
installed.
When the LED turns a solid blue, the appliance is ready for login.
Note - The LED is red if there is an alert or error.
3. Connect the standard network cable to the LAN1 port and to the network adapter on your PC.
4. If you use an external modem:
Connect the Ethernet cable to the WAN port on the appliance back panel and plug it into your
external modem or router's PC/LAN network port. The Internet LED on the appliance front panel
lights up when the Ethernet is connected.
Note - Wait 10 seconds between power cycles (off and on).
Quantum Spark 1600 / 1800 Appliance R80.20.XX Getting Started Guide | 10
Connecting the Cables