Authentication Details - Check Point QUANTUM SPARK 1900 Getting Started Manual

Authentication Details

In the Authentication Details page, enter the required details to log in to the appliance WebUI,
or if the wizard terminates abnormally:
n Administrator Name - We recommend that you change the default "admin" login name
of the administrator. The name is case sensitive.
n Password - A strong password has a minimum of 8 characters with at least one capital
letter, one lower case letter, and a special character. Use the Password strength meter
to measure the strength of your password.
Note - The meter is only an indicator and does not enforce creation of a
password with a specified number of character or character combination. To
enforce password complexity, click the checkbox.
n Confirm Password - Enter the password again.
n Country - Select a country from the list (for wireless network models only).
The country where the license is set determines the wireless frequency and parameters,
as the regulations vary according to region.
If you are using a trial license, only basic radio settings, are allowed in all zones. A
warning that selected wireless radio settings are not applied shows on the Summary
page and also on the Device > License page. For more information on basic wireless
radio settings, see sk159693.
If you select a country and install a valid license, but the wireless region of the device
does not match the selected country, a warning message shows and you must edit the
country information. When the country and wireless region match, you see the full
settings.
Quantum Spark 1900 / 2000 Appliance Getting Started Guide | 17
Authentication Details