Boot Up And Log In - Direct System Configuration; Boot Up And Log In - Static Ip System Configuration; Updating Operating System And Applications - Dell Edge Gateway 3003 Installation And Operation Manual

Prerequisites for setting up Ubuntu Core 16
Infrastructure
An active connection to the internet is needed to update the Ubuntu Core 16 operating system as well as applications (snaps).
Prior knowledge
● Ensure the personnel setting up Ubuntu Core 16 operating system has prior knowledge of the following:
○ Unix\Linux commands
○ Serial communication protocol
○ SSH terminal emulators (for example, PuTTY)
○ Network settings (for example, proxy URL)
Boot up and log in – Direct system configuration
1. Power on the Edge Gateway. The system sets up the operating system automatically and restarts multiple times to apply all
the configurations. The system takes approximately one minute to boot to the operating system.
2. When prompted, log in using the default credentials. The default user name and password are both admin. The default
computer name is the service tag.
For example;
Ubuntu Core 16 on 127.0.0.1 (tty1)
localhost login: admin
Password: admin
Boot up and log in – Static IP system configuration
This allows you to connect your Edge Gateway through a host computer, which must be on the same subnet.
NOTE: The static IP address of Ethernet port two on the Edge Gateway is set to these values at the factory:
● IP address: 192.168.2.1
● Subnet mask: 255.255.255.0
● DHCP server: Not applicable
1. On the host computer, configure the Ethernet adaptor that is connected to the Edge Gateway with a static IPv4 address
under the same subnet. Set the IPv4 address to 192.168.2.x (where x represents the last digit of the IP address, for
example, 192.168.2.2).
NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between
192.168.2.2 to 192.168.2.254.
2. Set the subnet mask to 255.255.255.0.

Updating operating system and applications

After enabling the network connections and connecting to the internet, Dell recommends to have the latest OS components and
applications installed. To update Ubuntu Core 16, run:
admin@localhost:~$ sudo snap refresh
50 Setting up the operating system