A Series - Panasonic SQ4-C11 Instruction Manual

Controller for safety liquid leak sensor sq4-a series
Hide thumbs Also See for SQ4-C11:
Table of Contents

Advertisement

Wiring
When wiring safety liquid leak sensor to this device, mount easy insulation displacement con-
nector CN-EP
Used easy insulation displacement connector depends on type of safety liquid leak sensor,
so refer table below. Also, In case the cable of the safety liquid leak sensor is extended, use
different type of displacement conecotor. Choosing easy insulation displacement connector
depends on the wire cover diameter.
Type
Model No. Crimp color Proper sensor
CN-EP2
Displacement
connector
CN-EP3
1 2 3 4
Step 2 Insert the wire into the wire inlet of easy insulation displacement connector until its end
comes in contact with the back.
Step 3 Crimp the easy insulation displacement connector with pliers.
• Place pliers parallel to the easy insulation displacement connector and crimp the
• Be careful not to damage the wire with pliers.
• Crimp the connector carefully so that the wire may not be disconnected.
18
Yellow
SQ4-A21-
Orange
SQ4-A22-
Lock release lever
Crimp area
Terminal No.
Color code
1
Brown
2
White
3
Blue
4
Black
20mm or more
Wire
Wire
Cable type
Wire cover diameter.
PVC cable
ø1.0 to ø1.15mm
PFA cable
ø0.6 to ø0.9mm
Wire insertion port
Terminal name
+V
Detection auxiliary output
0V
Detection output
Not good
Insert it until it is in contact
Pliers
MJE-SQ4C11 No. 0095-80V

Advertisement

Table of Contents
loading

Table of Contents