How To Assemble Your Switch Housing And Cap - Fanimation PENDRY 56 FPD6865 Series Manual

How to Assemble Your Switch Housing and Cap

1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
2. Assemble the switch housing assembly to the
support bracket using the two key slots in the
switch housing assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
3. Remove one of the three screws in the switch
housing assembly. Retain the screw for later and
slightly loosen the remaining two screws. (Figure 3 )
4. Assemble the light kit wire cover assembly to the
switch housing assembly using using the two key slots
in the light kit wire cover assembly. Replace the
previously removed screw and securely tighten all
three screws. (Figure 4 )
5. Assemble the cap to the switch housing assembly
by twisting in a clockwise direction. (Figure 5 )
Motor
Assembly
Switch Housing
Assembly
Switch Housing
Assembly
Light Kit Wire
Cover Assembly
15
Figure 1
Figure 2
Figure 3
Switch Housing
Assembly
Figure 4
Switch Housing
Assembly
Cap
Figure 5