Operation - Husqvarna LG 300 Operator's Manual

• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To do before you operate the product
• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 14 .
To set the handle to operation position
WARNING: Hold the handle tightly when you
change the position of the handle. There is a
risk of injury if the handle falls on you.
1. Hold the handle.
2. Release the lock lever and lower the handle
carefully.
To start and stop the product
WARNING: Keep your feet away from the
product during the start procedure. The
hydraulic system can cause the product to
move suddenly when the engine starts.
1222 - 002 - 06.04.2020
•
•

Operation

To start the product (LG 300, Honda)
1. Open the fuel valve.
Maintenance
2. Set the throttle control to idle speed.
3. Set the choke control in the correct position.
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
Let an approved service center do servicing on the
product regularly.
a) If the engine is cold, close the choke.
b) If the engine is warm or the ambient temperature
is high, open the choke.
11