Weather Guard Lo-Side Box Installation Manual

READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE INSERTING A KEY INTO THE LOCKS
This box has code-able locks installed. These locks have no pre-set key code, and only Weather Guard Key codes B001 thorough B050 can be
used. These locks will "learn" the code of the first key that the lock is coded with (See CODING THE LOCKS below).
One pair of identical keys will be provided per box.
If you have multiple boxes with code-able locks, you can:
1. Code each of the boxes with a single key.
OR
2. Code each box or set of boxes with their own set of keys.
Any new additional boxes with code-able locks can be coded with the keys from your original box.
Register your box and key code at weatherguard.com, and keep personal record of your key code, as there is no way to determine your key code
should you lose your keys.
Extra sets of keys can be purchased by contacting one of the following:
Customer Service: 1-800-456-7865
Website: weatherguard.com
NOTICE: ONCE A LOCK IS CODED, IT CANNOT BE CHANGED!
1
OPEN THE BOX LID & INSERT THE KEY
Code multiple boxes on a truck or
entire fleet to the same key
3 REMOVE KEY
TESTING THE LOCK I
©2023 Werner Co.
CODING THE LOCKS - Easy 3-step guide
TM
Lock and unlock the box 5 times to ensure it works. Remove key fully between each test.
2
ROTATE KEY A FULL
During key coding,
there WILL be resistance.
Continue through rotation.
The lock is now permanently coded.
Make sure to register your key code.
⁄
3
OF A CIRCLE
4
End
Start
Part No. 24-00156 Rev A