2.5.3 Creating a Base Screen → Saving Data
This section provides the procedure covering the steps from creating a sample of the base
screen with the file manager to saving this sample. The following procedure assumes that you
have already started GTWIN and displayed the file manager.
Procedure
1. Double-click a screen number in the file manager displayed on the left side
of GTWIN.
The editing screen for the screen corresponding to the selected screen number is
displayed.
2. On the [View] menu, select [Parts Library Window].
The parts library is displayed on the right side of GTWIN. In the following figure,
the base screen [B-0] and the [Switch] parts library have been selected.
If the parts library is already displayed, there is no need to perform this operation.
2.5 GTWIN Ver. 3 Usage Procedures
2-17