Vitek VT-2525 Instructions

ENGLISH
CURLING TONGS VT-2525 • Do not allow children to touch the unit
The unit is intended for hair crimping. body, the power cord or the power
plug during operation of the unit.
DESCRIPTION • Do not leave children unattended to
1. Heating plates avoid them using the unit as a toy.
2. On/off button with the light power • Close supervision is necessary when
indicator children or disabled persons are near
3. Hanging loop the operating unit.
4. Plates lock • This unit is not intended for usage by
children.
ATTENTION! • During the unit's operation and breaks
Do not use the unit near water in bath- between operation cycles, place the
rooms, showers, swimming pools etc. unit out of reach of children.
• When using the unit in the bathroom, • The unit is not intended to be used
unplug it right after usage by tak- by people with physical, sensory or
ing the power plug out of the mains mental disabilities (including chil-
socket, as closeness of water is dan- dren) or by persons lacking experi-
gerous even if the unit is switched off. ence or knowledge if they are not
• For additional protection you can under supervision of a person who is
install a residual current device (RCD) responsible for their safety or if they
with nominal operation current not are not instructed by this person on
exceeding 30 mA into the bathroom the usage of the unit.
mains; contact a specialist for instal- • Do not use the unit when you are
lation. drowsy.
• Place the curling tongs onto a flat, • Do not use the unit to style wet hair or
steady, heat-resistant surface. Make syntheticwigs.
sure that the heating plates and outer • Take the unit by its handle only. Do not
operating surfaces do not touch fus- touch the unit body in the area of the
ible and inflammable objects (plas- heating plates.
tic, polyethylene, synthetic materi- • Avoid contact of heated surfaces with
als etc.) your face, neck and other parts of
your body.
SAFETY MEASURES • Do not put the operating unit on
Before using the electrical unit, read this heat-sensitive or soft surfaces (for
instruction manual carefully and keep it instance, bed or sofa) and do not
for future reference. cover the unit.
Use the unit for its intended purpose only, • Be careful! The heating plates and the
as specified in this manual. Mishandling unit body in the area of the heating
of the unit may lead to its breakage and plates stay hot for some time after the
cause harm to the user or damage to his/ unit is unplugged.
her property. • It is recommended to unwind the
• Before switching the unit on, make power cord to its full length while
sure that voltage of the mains corre- using the unit.
sponds to unit operating voltage. • The power cord may not:
• Never leave the operating unit unat- – touch hot objects,
tended. – run over sharp edges,
• Do not switch the unit on in places – be used as a handle for carrying
where aerosols are sprayed or highly the unit.
flammable liquids are used. • Check the integrity of the power cord
• Apply the hair spray only after hair periodically.
styling is finished. • If the power cord is damaged, it
• Always unplug the unit immediately should be replaced by the manufac-
after usage and before cleaning. turer, a maintenance service or similar
• When unplugging the unit, pull the qualified personnel to avoid danger.
plug but not cord. • Do not attempt to repair the unit.
• Do not touch the unit body and the Do not disassemble the unit by your-
power plug with wet hands. self, if any malfunction is detected or
• Do not hang or keep the unit in places after it was dropped, unplug the unit
where it can fall into a bath or a sink and apply to any authorized service
filled with water; do not immerse the center at the contact addresses given
unit body, power cord or power plug in the warranty certificate and on the
into water or other liquids. website www.vitek.ru.
• Do not use the unit while taking a • To avoid damages, transport the unit
bath. in the original package only.
• If the unit is dropped into water, • Keep the unit in a dry cool place
unplug it immediately and only then out of reach of children and disabled
take it out of water. persons.
• For children safety reasons do not
leave polyethylene bags used as a THIS UNIT IS INTENDED FOR HOUSE-
packaging unattended. HOLD USE ONLY. ITS COMMERCIAL
Attention! Do not allow children to play USAGE AND USAGE IN PRODUCTION
with polyethylene bags or packaging AREAS AND WORK SPACES IS PRO-
film. Danger of suffocation! HIBITED.
2
BEFORE THE FIRST USE STORAGE
• Always unplug the unit if it is not being
After unit transportation or storage
at low temperature keep it for at least used.
three hours at room temperature • Let the unit cool down completely
before switching on. before taking away for storage.
• Unpack the unit and remove any adver- • Never wind the power cord around the
tising stickers that can prevent the unit unit, as it can damage the cord.
• You can store the unit by hanging it on
operation.
the loop (3) provided that no water gets
• Unwind the power cord to its full length.
on the unit in this position.
• Check the unit for damages, do not use
• Keep the unit in a dry cool place out
it in case of damages.
of reach of children and people with
• Before plugging the unit in make sure
disabilities.
that the operating voltage of the unit
corresponds to the voltage of your
DELIVERY SET
mains.
Curling tongs – 1 pc.
Warranty certificate – 1 pc.
HAIR CRIMPING
Instruction manual – 1 pc.
• Only use the unit on healthy, undyed,
and not permed hair.
TECHNICAL SPECIFICATIONS
• If your hair has been dyed or permed,
Power supply: 220-240 V ~ 50 Hz
use the unit rarely.
Rated input power: 52 W
• For the best results the hair should be
Maximal heating temperature: 210 °С
clean and dry.
• Open the curling tongs by pressing the
heating plates (1) together and moving
the clamp (4).
• Put the unit on a flat steady and heat-
resistant surface. ATTENTION! Do not use the unit near
• Insert the plug into the mains socket. water in the bathrooms, showers, swim-
• Switch the unit on by pressing the but- ming pools etc.
ton (2), the power indicator (2) will light
up and start flashing. RECYCLING
Note: During the first operation some
smell from the heating element is pos-
sible, this is normal.
• Divide combed hair into locks of equal
width (about 2 cm).
For environment protection do not throw
• Place a hair lock between the heating
out the unit and the batteries (if included),
plates (1).
do not discard the unit and the batter-
• Press the hair lock between the heating
ies with usual household waste after the
plates (1) near the hair roots and cre-
service life expiration; apply to specialized
ate crimps throughout the hair length.
centers for further recycling.
• Do not slide the unit throughout the
The waste generated during the disposal
hair lock length, just press the heat-
of the unit is subject to mandatory col-
ing plates (1) together to make crimps.
lection and consequent disposal in the
IMPORTANT: do not keep the heating
prescribed manner.
plates on the same area of the hair lock
For further information about recycling
for more than 2 seconds.
of this product apply to a local municipal
• After that start styling the next hair
administration, a disposal service or to the
lock.
shop where you purchased this product.
• Cool your hair down before final styling
or applying hair spray.
The manufacturer preserves the right to
• Avoid contact of heated surfaces with
change design, structure and specifica-
your face, neck and other parts of
tions not affecting general principles of
your body.
the unit operation without a preliminary
• After use set the power switch (2) to
notification due to which insignificant dif-
the lower position, the indicator (2) will
ferences between the manual and product
go out; then take the power plug out of
may be observed. If the user reveals such
the socket. Let the device cool down.
differences, please report them via e-mail
Note:
info@vitek.ru for receipt of an updated
– Always switch the unit off and unplug it
manual.
if it is not used.
– Never leave the unit connected to the
Unit operating life is 3 years
mains unattended.
Guarantee
CLEANING AND CARE
Details regarding guarantee conditions
• Before cleaning, unplug the unit and let
can be obtained from the dealer from
it cool down completely.
whom the appliance was purchased. The
• Never immerse the unit into water or
bill of sale or receipt must be produced
other liquids.
when making any claim under the terms
• Wipe the heating plates and the unit
of this guarantee.
body with a soft damp cloth and then
This product conforms to the EMC
wipe them dry.
Directive 2014/30/EU and to the
• Do not use abrasives and solvents to
Low Voltage Directive 2014/35/EU.
clean the unit.
3